D20 Lamp Setup and Care
Use these instructions from the A&B1 care sheet to set up your hovering D20 display.
Setup
-
Unpack the components
Carefully remove the D20, display stand, power cord, and A&B1 spacer tool from the packaging.
-
Prepare the stand
Place the stand on a flat, level surface for proper balance.
-
Connect power
Plug the power cord into the stand and a wall outlet. The LED lights turn on when the stand is powered correctly.
-
Position the D20 and spacer
Find the top of the D20: the side with numbers 19, 6, 17, 3, and 13. Hold the A&B1 spacer tool against this side. Position it so the spacer sits between the top of the D20 and the underside of the stand.
-
Achieve hover
Gently release the D20 while keeping the spacer in place. Once the die hovers steadily, slowly remove the spacer without disturbing it. Lightly tap the D20 in either direction to start smooth rotation.
Care and cautions
- For display use only. Do not roll the D20, as this may damage internal components.
- Keep the display dry and avoid moisture. Use approved power outlets.
- The D20 will fall if the stand is unplugged or during a power outage.
- Wipe with a soft, damp cloth. Do not use alcohol cleaners.
- Magnets may interfere with pacemakers. Consult your physician before using or operating a hovering D20.
Warranty and support
The care sheet specifies a 60 day limited warranty and directs customers to www.aandb1.com. For setup or warranty help, email support@hoveringhexes.com with your order number and a photo or short video of your setup.